Support Arm Systems

REQUEST INFORMATION »

Support arm systems / equipment carrier systems

  The support arm/equipment carrier system from RK is a component program which can be selected according to individual requirements. For simple applications with lighter loads we offer the GT-48 program, which is connected by means of round tubes. For medium to heavy loads we recommend the GT-50/60 or 80 support arm system. This is connected by means of square tubes and can withstand much heavier loads. Assembling the support arms could not be easier Adjustable end stops make it possible to adjust the pivot range. Moreover, the pivotal forces can be distributed to the various load-bearing capacities, making the system more comfortable to operate. The preformed tube supports in the elements facilitate alignment of the support arm and, since the adjusting screws are easy to access without having to disassemble the bellows, assembling and setting up the system is also easier.
GT48 equipment carrier/support arm system for round tubes

GT48 equipment carrier/support arm system for round tubes

 

GT-48 support arm system (round tubes)

  • Industrial support arm system for control equipment housing
  • Modular design of the individual components
  • Protected, internal cable routing
  • Protection rating IP54 according to EN 60529
  GT50/60/80 equipment carrier/support arm system for square tubes

GT50/60/80 equipment carrier/support arm system for square tubes

 

GT-50/60/80 support arm system (square tube)

  • Robust industrial square tube support arm system for control components
  • Modular design of the individual components
  • High load-bearing capacity, wide radius of action
  • Protection rating IP65 according to EN 60529
 

Examples of support arm system superstructures

Figs show GT-50/60/80 support arms. See catalogue (PDF) for examples of GT-48